Generation working and Compilation of MARTe components

EC-GN-JA-PCF/target/main/resources/qst-gyrotron-fast-controller/Test_P01/test.py

@@ -0,0 +1,90 @@
+#!/usr/bin/python
+
+import time
+import sys
+import subprocess
+
+import test_async
+import test_sync
+import test_ready_hw
+import test_setup_hw
+import test_standby_hw
+import test_ready
+import test_setup
+import test_standby
+
+#
+# Some EPICS PVs need to be simulation mode when we test code without PXI board.
+# When user uses sim mode, new value must be written into PV.SVAL and PV itselfself.
+#
+print '### Start State Machine Sequence Test ###'
+
+print '---------- Pre setup for the test ----------'
+test_setup.test_setup()
+#test_setup_hw.test_setup()
+
+print 'Enter to continue test:'
+inpval = raw_input()
+################################################################################
+# set SELECT and STANDBY signal
+################################################################################
+print '---------- WatiStandby test ----------'
+test_standby.test_standby()
+#test_standby_hw.test_standby()
+
+print 'Enter to continue test'
+inpval = raw_input()
+
+################################################################################
+# set READY and CCPS_ON_REQUEST signal
+################################################################################
+print '---------- WatiReady test ----------'
+test_ready.test_ready()
+#test_ready_hw.test_ready()
+
+print 'Enter to continue test'
+inpval = raw_input()
+################################################################################
+# set PERMIT and ON  signal
+################################################################################
+print 'Simulate PERMIT signal. State should go to WaitHVON state'
+while(1):
+    print '''Select test type and push enter key:
+        1: GYA / Async mode
+        2: GYB / Async mode
+        3: Two Gyrotron operation
+        4: Mode limit detection
+        5: Short pulse
+        6: Long pulse
+        7: PrePro operation
+        8: SYNC mode operation
+        9: GYA / Async mode --- operator set delay and pulse length on HMI
+        10: GYB / Async mode --- operator set delay and pulse length on HMI
+    '''
+    inpval = raw_input()
+
+    if inpval == "1":
+        test_async.test_async_GYA()
+    elif inpval == "2":
+        test_async.test_async_GYB()
+    elif inpval == "3":
+        test_async.test_async_both()
+    elif inpval == "4":
+        test_async.test_async_limit()
+    elif inpval == "5":
+        test_async.test_async_shortpulse()
+    elif inpval == "6":
+        test_async.test_async_longpulse()
+    elif inpval == "7":
+        test_async.test_async_prepro()
+    elif inpval == "8":
+        test_sync.test_sync()
+    elif inpval == "9":
+        test_async.test_async_GYA_manual()
+    elif inpval == "10":
+        test_async.test_async_GYB_manual()
+    else:
+        print 'invalid value. Enter 1 to 10!'
+        continue
+
+print '..... End of test code .....'